WiFi
AECC Dongle Setup Guide
This guide explains how to set up the GivEnergy AECC Multi-Connect Dongle, used on All in One 2, Gateway 2, and Gen 4 inverters. The dongle supports LAN, WiFi, Bluetooth, and 4G fallback and must be configured before your system can come online. ...
WiFi 6 Installation & Setup Guide
This guide explains how to install and configure the GivEnergy WiFi 6 Dongle. The process is the same for both internal and external WiFi 6 dongle models. Follow each step carefully to ensure your inverter connects securely to your home WiFi network. ...
WiFi Security Level Connection Fix
If you are having trouble connecting your GivEnergy system to your WiFi, it may be due to compatibility with your router’s security settings. Follow the steps below to resolve the issue. Step 1: Check and Adjust WiFi Security Level Some GivEnergy ...
WiFi Dongle Security when using LAN
It is important to remember that when utilising LAN as your connection method, you will still need to secure the internal Wi-Fi dongle for network security purposes. Failure to do so will leave the access point open and the customers network ...
Quick Setup
Plug in and secure the dongle. Connect your device to the dongle WiFi. Go to 10.10.100.254 and log in (admin/admin). Switch to STA Mode. Scan, select your WiFi network, and enter the password. Check security settings: WPA2-PSK / AES. Restart the ...
WiFi Dongle Troubleshooting
Common Issues If WiFi is password-protected, try the inverter serial number as the password. Reset the dongle by holding the button for 15 seconds, then wait 30 minutes before retrying. Only one device can connect to the dongle at a time. If you’ve ...
Adding a WiFi Extender
If your inverter is far from the router: Install a WiFi extender midway between the inverter and router. Use a unique SSID (e.g. add _EXT). Ensure extender is on 2.4GHz only. Disable 5GHz if needed.
Restarting the Dongle
Navigate to Device Management. Select Restart Module. The message may say “Rebooting” indefinitely; allow up to 10 minutes for reconnection. If still offline after 10 minutes, refresh the page and retry.
WiFI Configuration
STA Interface Settings Click Search to scan for available WiFi networks. Select the customer’s WiFi network. Verify: RSSI (Signal Strength): ≥70% preferred. Channel/Frequency: Note this value for later AP setup. Enter the WiFi password in the ...
Connecting to the Dongle
On your phone, locate the dongle’s WiFi SSID (e.g. WF######) and connect. If prompted for a password, use the inverter serial number (e.g. 12345678) or the password set by the installer. Open a browser and go to 10.10.100.254. Log in with: Username: ...
Internal WiFi Modules
Some models include built-in WiFi instead of requiring a dongle: Inverter Type Serial Prefix Gen 2 Hybrid WG Gen 3 Hybrid WH All-in-One WJ Giv-Gateway WK To enable internal WiFi, remove the inverter’s bottom cover and set the DIP switches to WiFi ...
WiFi Dongle Setup
Insert the dongle into the USB port on the underside of the inverter. Screw it in firmly on both sides. Check the dongle lights: Flashing: Connecting. Solid: Connected. If the inverter is not powered, the dongle can be powered from any USB source.
Router Compatibility Checklist
Before attempting to connect or reconnect your inverter to the internet, confirm the following with your internet provider: Enable both 2.4GHz and 5GHz channels and ensure they are split. If your router cannot split channels, request a Guest 2.4GHz ...