Internal WiFi Modules

Internal WiFi Modules

Some models include built-in WiFi instead of requiring a dongle:

Inverter TypeSerial Prefix
Gen 2 HybridWG
Gen 3 HybridWH
All-in-OneWJ
Giv-GatewayWK

To enable internal WiFi, remove the inverter’s bottom cover and set the DIP switches to WiFi Mode (see the installation manual). Even when using LAN, secure the WiFi module to prevent network exposure.

    • Related Articles

    • WiFi 6 Installation & Setup Guide

      This guide explains how to install and configure the GivEnergy WiFi 6 Dongle. The process is the same for both internal and external WiFi 6 dongle models. Follow each step carefully to ensure your inverter connects securely to your home WiFi network. ...

    • WiFi Dongle Security when using LAN

      It is important to remember that when utilising LAN as your connection method, you will still need to secure the internal Wi-Fi dongle for network security purposes. Failure to do so will leave the access point open and the customers network ...

    • WiFI Configuration

      STA Interface Settings Click Search to scan for available WiFi networks. Select the customer’s WiFi network. Verify: RSSI (Signal Strength): ≥70% preferred. Channel/Frequency: Note this value for later AP setup. Enter the WiFi password in the ...

    • Adding a WiFi Extender

      If your inverter is far from the router: Install a WiFi extender midway between the inverter and router. Use a unique SSID (e.g. add _EXT). Ensure extender is on 2.4GHz only. Disable 5GHz if needed.

    • WiFi Dongle Troubleshooting

      Common Issues If WiFi is password-protected, try the inverter serial number as the password. Reset the dongle by holding the button for 15 seconds, then wait 30 minutes before retrying. Only one device can connect to the dongle at a time. If you’ve ...

    GivBot