Connecting to the Dongle

Connecting to the Dongle

  1. On your phone, locate the dongle’s WiFi SSID (e.g. WF######) and connect.
  2. If prompted for a password, use the inverter serial number (e.g. 12345678) or the password set by the installer.
  3. Open a browser and go to 10.10.100.254.
  4. Log in with:
    • Username: admin
    • Password: admin
  5. Navigate to Mode Selection, select STA Mode, and click Apply.

    • Related Articles

    • WiFi Dongle Setup

      Insert the dongle into the USB port on the underside of the inverter. Screw it in firmly on both sides. Check the dongle lights: Flashing: Connecting. Solid: Connected. If the inverter is not powered, the dongle can be powered from any USB source.

    • AECC Dongle Setup Guide

      This guide explains how to set up the GivEnergy AECC Multi-Connect Dongle, used on All in One 2, Gateway 2, and Gen 4 inverters. The dongle supports LAN, WiFi, Bluetooth, and 4G fallback and must be configured before your system can come online. ...

    • WiFi Dongle Troubleshooting

      Common Issues If WiFi is password-protected, try the inverter serial number as the password. Reset the dongle by holding the button for 15 seconds, then wait 30 minutes before retrying. Only one device can connect to the dongle at a time. If you’ve ...

    • WiFi Dongle Security when using LAN

      It is important to remember that when utilising LAN as your connection method, you will still need to secure the internal Wi-Fi dongle for network security purposes. Failure to do so will leave the access point open and the customers network ...

    • WiFi 6 Installation & Setup Guide

      This guide explains how to install and configure the GivEnergy WiFi 6 Dongle. The process is the same for both internal and external WiFi 6 dongle models. Follow each step carefully to ensure your inverter connects securely to your home WiFi network. ...

    GivBot