Setting the LoRa Module Channels Guides

Setting the LoRa Module Channels Guides

Step One

Using an RS485-USB adapter, connect a 2 core cable between the adapter and the lora module as shown in the diagram below

 

Step Two

Plug the RS485-USB Adapter into a laptop or computer and ensure that the RS485 Adpater can be seen with an Open COM Port. 

Step Three

Using a Pin or small screwdriver, press in and hold the Deploy Button on the Front of the Lora Module until the Green LED on the front starts to flash 

Step Four

Open up the LoRa software and configure the following settings: 

  1. Select the relevant port and open communication between the software and the LoRa Module.
  2. Press read and it will display the current set channel.
  3. Change to the desired channel from the drop-down list. Please note if using more than 1 set of modules on the same site, the channel will need setting far apart so that the frequencies are not too close together.
  4. Press write to set the new settings on the LoRa Module
  5. Press Reset

    • Related Articles

    • LoRa Configuration

      Note: This guide is intended for use with LoRa devices with a digital display only. Main Display in LoRa Radio Mode LoRa Mode Antenna 240VAC RS-485 L N Signal strength / Signal to noise ratio Frequency info / Spread factor Serial Port Settings Set to ...

    • Understanding LoRa Communication Between Inverter and Meter

      Overview LoRa (Long Range Radio) enables wireless communication between GivEnergy inverters and energy meters, eliminating the need for hardwired connections over long distances. How It Works The LoRa module in the inverter transmits data to the LoRa ...

    • Common Wiring Mistakes When Installing LoRa

      Overview Incorrect wiring can cause communication failures between the inverter and the meter. This guide outlines common mistakes and how to avoid them. Common Errors Mistake Description Corrective Action Using wires from two different pairs Mixing ...

    • How to Wire the GivEnergy LoRa Data Cable

      Overview This guide explains how to correctly wire the GivEnergy LoRa Data connection between the inverter and the meter for Gen3 systems. Correct wiring ensures stable data communication and prevents signal loss between devices. Wiring Instructions ...

    • Setting Up a GivEnergy Installer Account

      To create a GivEnergy Installer account, please provide the following details: Wholesaler Name Company Name Company Address Company Email Company Phone Number GivEnergy Installer Number / Certificate Date (attach certificate) If your wholesaler is ...

    GivBot